IMA 60 Installation Mixing Amplifier 65W
Installation Mixing Amplifier 65W @ 4 Ohms / 100 V / 70 V
Specifications
-Product type Installation mixer preamplifier
-Emergency input 1 balanced line input
-Mic/ line inputs 2
-Mic-/ Line Input Connectors 2 unbalanced stereo line inputs, Bluetooth 4.0
-Music sources 2 unbalanced stereo line inputs, Bluetooth 4.0
-Line outputs 1
-Reinforced Main Outputs 1 with output mode selector (Low-Z/High-Z)
-Cooling Convection
-Priority levels 4
Emergency Input
-Nominal input sensitivity -15 dBu (Sine 1 kHz, gain max)
-Nominal input clipping 20 dBu (Sine 1kHz)
-Priority Contact closure +5VDC normally open for dry contact
-Connector 5-pin Terminal Block, pitch 5.08mm
Mic/Line inputs 1-2
-Nominal input sensitivity Mic Mic: -40 dBu (sine 1 kHz, gain max)
-Nominal input sensitivity lineLine: -17 dBu (sine 1 kHz, gain max)
-Nominal input clipping Mic Mic: -5 dBu (Sine 1kHz)
-Nominal input clipping lineLine +19dBu (Sine 1kHz)
-Phantom power + 24V, 10mA switchable
-Connector Mic/ Line1 5-pin Terminal Block, pitch 5.08mm, XLR/6.3 mm jack
-Connector Mic/Line 21 dual RCA Mono Summed, 3-pin Terminal Block, pitch 5.08mm, Pitch 5.08mm
Music inputs - CD/AUX
-Nominal input sensitivity CD/AUX - 6.22 dBV (Sine 1 kHz, Gain max)
-Connector CD/AUX 2 x dual RCA Mono Summed
Amplifier Output
-Amplifier Outputs High-Z: 70V or 100V outputs, Low-Z: 4 ohm minimum load
-Preamplifier input 5-pin Terminal Block, pitch 5.08mm
-RMS Power ( W ) 65 W (Continuous sine wave 1kHz, 4 ohm load)
-Power ( Peak ) (W) 70 W (100 msec sine 1kHz Burst @ 4 ohm load)
-Frequency range 20 Hz - 20 kHz (LO-Z, -3 dB), 60 Hz - 20 kHz (HI-Z, -3 dB)
-Tone controlBass +/-10 dB (100 Hz)
-Tone control Treble +/-10 dB (10 kHz)
-Protection circuits Audio Limiter, over-current, short circuit, thermal overload
Aux Output
-Connector AUX-output 3-pin Terminal Block, pitch 5.08 mm
-Maximum gain 22 dB
Power Supply
-Operating voltage 100 V AC - 240 V AC, 50 - 60 Hz
-Power consumption (max.) Line: -17 dBu (sine 1 kHz, gain max)
-Idle power consumption 7.5 W (no signal input)
-Power Consumption @ Standby <1 W
-Operating temperature ( non-condensing ) 0°C - 40°C; < 85% humidity
-Dimensions (W x H x D) ( height with rubber feet )210 (W)x 95 (H) x 266.76 (D)mm